After the execution of the JCXZ (Jump if CX is Zero) instruction, how is register CX or the FLAGS register modified?
Ch 09: Software Interrupts and DOS/BIOS Services
Covers IVT structure (256 vectors x 4 bytes each = 1KB), pushing flags and CS:IP during interrupt invocation, hooking existing software interrupts, and invoking DOS function calls for disk and character I/O.
174 Questions174 MCQs0 Short Questions0 Long Questions
SEMESTER PASS
CS401 - Computer Architecture and Assembly Language Programming Examination Practice
Timed practice exam simulation for CS401 - Computer Architecture and Assembly Language Programming.
Showing 121 โ 130 of 174 Questions
Page 13 of 18
A Far jump instruction in 8088 assembly language is not position-relative but is:
The conditional jump instructions JC (Jump if Carry) and JNC (Jump if No Carry) test the state of which CPU status flag?
What are the three fundamental classifications of jump instructions supported in 8088 assembly language?
If register AX contains decimal -2 (0xFFFE) and register BX contains decimal 2 (0x0002), what happens after executing 'CMP AX, BX' followed by 'JA label'?
In x86 assembly language, the conditional jump instruction JNZ (Jump if Not Zero) causes execution to branch when:
When a relative branch offset address is encoded as a 16-bit word within the current code segment, the branch instruction is known as a:
In x86 assembly language, the Instruction Pointer (IP) cannot be modified directly using 'MOV IP, label'. Which single valid instruction replaces this illegal assignment to transfer execution control to a label?
If AX contains decimal -2 (0xFFFE in 16-bit hex) and BX contains decimal 2 (0x0002 in hex), what will happen after executing 'CMP AX, BX' followed by 'JA label'?
True or False: The JA (Jump if Above) instruction will NOT execute a jump after a CMP instruction if the unsigned destination operand is greater than the source operand.